I am building a twin with brushless motors. I have had conflicting advice how to connect the two ESCs Rx plugs to the aircraft Rx.
On the one hand it was suggested just put both ESC plugs into a Y lead and then into the A/C Rx. On the other hand I was advised to put
one plug into the Y lead, cut the red wire in the other and then plug into the Y lead.
Neither works for me. Suggestions please.
Ian, The latter is the correct answer. If you plug both ESC leads into a Y lead (assuming they aren’t Opto ESC’s) without removing the red wire from one (don’t cut it – just remove it from the plug and tape it up to the lead) then the BEC’s will potentially interact with one another. Why doesn’t this work for you?